Primary Burette Drive (Fixed) for AT/MKV-710 series
2,650.00 2,650.00 2650.0 USD
Primary Burette Drive for AT/MKV-710 series. Drive Only. (EBU-710-XXB Burette Unit (XXmL) not included.
Pump Tube WPX1
54.00 54.00 54.0 USD
Pump Tube (Fluorine Tube) WPX1 F-3.2-3 with Grease. For MKV-710 solvent exchange unit
EBU-710-KF Burette Unit
1,495.00 1,495.00 1495.0 USD
Swappable KF burette (10mL) Unit for volumetric Karl Fischer Titrator MKV-710
Small Cap
15.00 15.00 15.0 USD
Small Cap for the Aquapal III
Reagent Bottle; Clear, 1L
26.00 26.00 26.0 USD
985000035 Reagent bottle(1L/brown)
Sealed Cell Flask Assembly
1,527.78 1,527.78 1527.78 USD
Microtitration Assembly
1,737.93 1,737.93 1737.93 USD
KMTA-118-50: Microtitration Assembly
Microtitration Assembly
1,737.93 1,737.93 1737.93 USD
KMTA-118-5: Microtitration Assembly
Microtitration Assembly
1,737.93 1,737.93 1737.93 USD
KMTA-118-1: Microtitration Assembly
Touch Panel Controller
7,457.00 7,457.00 7457.0 USD
MCU-610 Touch Panel Controller for Titrator
KEM Amenity Meter
4,312.00 4,312.00 4312.0 USD
Constant Volume/Speed Injector
1,875.00 1,875.00 1875.0 USD
Metal fittings for affixing T500 and TW
370.37 370.37 370.37 USD
KAE4: Metal fittings for affixing T500 and TW
Hand-holder for T500 and TW
518.52 518.52 518.52 USD
KAE3: Hand-holder for T500 and TW
Pole for measurement with T500 & TW high places
518.52 518.52 518.52 USD
KAE2: Pole for measurement with T500 & TW high places
Support for T750
266.67 266.67 266.67 USD
KAE1: Support for T750
Evaporator (KF-610 series)
11,299.00 11,299.00 11299.0 USD
ADP-611 Evaporator

The ADP-611 is an evaporator/oven to be used and connected with a KF moisture titrator for moisture testing of solid samples, powder samples or samples that may interfere by side reaction if titrated by direct injection method.

-Type and model; Model ADP-611 Evaporator
-Heating method; Electrically conductive clear heater glass
-Temperature range; Control method: proportional
Setting range: 50 ~ 300°C Minimum temperature setting: 1°C
Temperature precision: ± 2°C
Temperature sensor: K-thermocouple
-Temperature display: LED digital 3 characters
-Heater unit : Pyrex glass tube φ 30 × 335mm
-Sample boat: Pyrex glass 68 L × 25 W × 15 H mm , Capacity 16mL
-Carrier gas: Nitrogen: not included in supplied parts./ Nitrogen gas, regulator, and tubing have to be prepared by user
-Gas dryer: Zeolite 100g 2 pcs
-Gas flow: 100 ~ 300 mL/min
-Dimension: 370 (W) × 195 (D) × 217 (H) mm
-Power: AC100 ~ 120V± 10% 50Hz/60Hz / AC220 ~ 240V± 10% 50Hz/60Hz (Pre-adjusted before shipment from the factory)
-Power Consumption: Approx. 300W
Weight: Approx. 5kg
Evaporator (for Karl Fischer testing heavy Oil)
8,850.00 8,850.00 8850.0 USD
ADP-513 Karl Fischer Oil Evaporator

-Digital temperature control
-Rotameter carrier gas flow control
-Built-in carrier gas drying system Operating temperature ambient up to 200°C Heated transfer tube
-Overheating protection
-Automatic cell evacuation system

Temperature Range: Room - 200°C
Heating method: Cartridge base heater
Ambient conditions: 5 - 35°C, less than 85% RH
Power: AC 200-240, 50/60Hz
Power Consumption: 400W
Dimensions: 320 x 210 x 330 mm
Weight: Approx. 6 kg
Evaporator for Ores
24,000.00 24,000.00 24000.0 USD
ADP-512 High Heat Evaporator for Ores for Karl Fischer

1) Measurement for micro amount of water is least affected from ambient moisture because the movement of
sample boat is controlled by magnet, operated outside the sealed heating unit, and thus accurate and reliable
results are assured.
2) The newly designed electric furnace operates in a wide range of degrees from room temperature up to 1000°C,
featuring relatively short warm-up time, taking approximately 30 minutes for temperature rise as well as for
equilibrium respectively.
3) PID control by the built-in thermostat provides an accurate and stable oven temperature.
4) The safety while working on the electric oven is secured because the maximum temperature over the oven
surface is always kept under 70°C.
5) The built-in excessive heat prevention unit is another safety measures with a thermometer in it, which is
separate from the sensor for temperature control.
6) This evaporator is equipped with two types of electric furnace (for low temperature and for high temperature),
which enables measurement for hygroscopic water as well as combined water without taking the sample out
of the oven.
Heat Extractor for Sugar Samples
2,985.00 2,985.00 2985.0 USD
ADP-344; Heat Extractor for Sugar Samples